Browse TRAIL Inventories

Control hinge-movement and effectiveness characteristics of several interchangeable tip controls on a 60©� delta wing at Mach numbers of 1.41, 1.62, and 1.96

Wind-tunnel investigation at low speed of the effect of varying the ratio of body diameter to wing span from 0.1 to 0.8 on the aerodynamic characteristics in pitch of the 45©� sweptback-wing--body combination

An experimental and theoretical investigation at high subsonic speeds of the effects of horizontal-tail height on the aerodynamic characteristics in sideslip of an unswept, untapered tail assembly

Impingement of Droplets in 90 deg Elbows with Potential Flow

Impingement of Water Droplets on NACA 65A004 Airfoil and Effect of Change in Airfoil Thickness from 12 to 4 Percent at 4 deg Angle of Attack

A Method for Determining Cloud-Droplet Impingement on Swept Wings

Comparison of Several Methods of Cyclic De-Icing of a Gas-Heated Airfoil

Component and over-all performance evaluation of a J47-GE-25 turbojet engine over a range of engine-inlet Reynolds number indices

Some effects of aeroelasticity and sweepback on the rolling effectiveness and drag of a 1/11-scale model of the Bell X-5 airplane wing at Mach numbers from 0.6 to 1.5

Investigation of gases evolved during firing of vitreous coatings on steel

A fundamental investigation of fretting corrosion

High-frequency pressure indicators for aerodynamic problems

Investigation of lateral control near the stall flight investigation with a light high-wing monoplane tested with various amounts of washout and various lengths of leading-edge slot

Interim report on a fatigue investigation of a full-scale transport aircraft wing structure

Investigation of sandwich construction under lateral and axial loads

A method for stabilizing shock waves in channel flow by means of a surge chamber

A method of deriving frequency-response data for motion of the center of gravity from data measured on an aircraft at locations other than the center of gravity

The flow about a section of a finite-aspect-ratio NACA 0018 airfoil on a transonic bump

Optimum controllers for linear closed-loop systems

On the use of a damped sine-wave elevator motion for computing the design maneuvering horizontal-tail load

On traveling waves in beams

One-dimensional, compressible, viscous flow relations applicable to flow in a ducted helicopter blade

New experiments on impact-pressure interpretation in supersonic and subsonic rarefied air streams

A new shadowgraph technique for the observation of conical flow phenomena in supersonic flow and preliminary results obtained for a triangular wing

Matrix methods for determining the longitudinal-stability derivatives of an airplane from transient flight data

Preliminary experimental investigation of low-speed turbulent boundary layers in adverse pressure gradients

Propeller-noise charts for transport airplanes

Lift and pitching moment at low speeds of the naca 64A010 airfoil section equipped with various combinations of a leading-edge slat, leading-edge flap, split flap, and double-slotted flap

Low-speed drag of cylinders of various shapes

Heat and momentum transfer between a spherical particle and air streams

Icing protection for a turbojet transport airplane : heating requirements methods of protection, and performance penalties

Impingement of water droplets on a cylinder in an incompressible flow field and evaluation of rotating multicylinder method for measurement of droplet-size distribution, volume-median droplet size, and liquid-water content in clouds

Friction and wear investigation of molybdenum disulfide I : effect of moisture

Heat transfer and skin friction by an integral method in the compressible laminar boundary layer with a streamwise pressure gradient

Water-landing investigation of a flat-bottom v-step model and comparison with a theory incorporating planing data

On the stability of the laminar mixing region between two parallel streams in a gas

Creep-buckling analysis of rectangular-section columns

Determination of boundary-layer transition Reynolds numbers by surface-temperature measurements of a 10 degree cone in various NACA supersonic wind tunnels

The effect of longitudinal stiffeners located on one side of a plate on the compressive buckling stress of the plate-stiffener combination

Analytical investigation of icing limit for diamond-shaped airfoil in transonic and supersonic flow

Combined effect of damping screens and streams convergence on turbulence

An analysis of statically indeterminate trusses having members stressed beyond the proportional limit

Behavior in pure bending of a long monocoque beam of circular-arc cross section

An analysis of normal-acceleration and airspeed data from a four-engine type of transport airplane in commercial operation on an eastern united states route from november 1947 to february 1950

Combined-stress fatigue strength of 76S-T61 aluminum alloy with superimposed mean stresses and corrections for yielding

Combustion instability in an acid-heptane rocket with a pressurized-gas propellant pumping system

The compressible laminar boundary layer with heat transfer and small pressure gradient

The effect of vertical chine strips on the planing characteristics of V- shaped prismatic surfaces having angles of dead rise of 20 degrees and 40 degrees

Effect of processing variables on the transition temperature, strength, and ductility of high-purity, sintered, wrought molybdenum metal

Effect of variation in rivet strength on the average stress at maximum load for aluminum-alloy, flat, z-stiffened compression panels that fail by local buckling


Published Year

Subject

Author

‹‹ previous 1 2 ... 44 45 46 47 48 49 50 ... 143 144 next ››