TRAIL - Technical Report Archive and Image Library

Force and Pressure-Distribution Measurements on a Rectangular Wing With a Slotted Droop Nose and With Either Plain and Split Flaps in Combination or a Slotted Flap

Effect of Modifications to Induction System on Altitude Performance of V-1710-93 Engine 3: Use of Parabolic Rotating Guide Vanes and NACA Designed Auxiliary-Stage Inlet Elbow and Interstage Duct

Frequency-Response Method for Determination of Dynamic Stability Characteristics of Airplanes With Automatic Controls

Flight Investigation on a Fighter-Type Airplane of Factors Which Affect the Loads and Load Distributions on the Vertical Tail Surfaces During Rudder Kicks and Fishtails

A Theoretical Investigation of Hydrodynamic Impact Loads on Scalloped-Bottom Seaplanes and Comparisons With Experiment

Dislocation Theory of the Fatigue of Metals

Coefficient of Friction, Oil Flow and Heat Balance of a Full-Journal Bearing

Spark-Timing Control Based on Correlation of Maximum-Economy Spark Timing, Flame-Front Travel, and Cylinder-Pressure Rise

On Similarity Rules for Transonic Flows

The Development of Jet-Engine Nacelles for a High-Speed Bomber Design

Calculations and Experimental Investigations on the Feed-Power Requirement of Airplanes With Boundary-Layer Control

Analytical Treatment of Normal Condensation Shock

Calibration and Measurement in Turbulence Research by the Hot-Wire Method

The Combination of Internal-Combustion Engine and Gas Turbine

Description of Russian Aircraft Engines "AM 35" and "AM 38"

Development and Construction of an Interferometer for Optical Measurements of Density Fields

Determination of the Stress Concentration Factor of a Stepped Shaft Stressed in Torsion by Means of Precision Strain Gages

Concerning the Velocity of Evaporation of Small Droplets in a Gas Atmosphere

Compressible Flow Tables for Air

Cones in Supersonic Flow

Compression Shocks of Detached Flow

The Distribution of Loads on Rivets Connecting a Plate to a Beam Under Transverse Loads

Drag Reduction by Suction of the Boundary Layer Separated Behind Shock Wave Formation at High Mach Numbers

The Calculation of the Heat Required for Wing Thermal Ice Prevention in Specified Icing Conditions

Systematic Wind-Tunnel Measurements on a Laminar Wing With Nose Flap

Wind-Tunnel Investigation of Icing of an Engine Cooling-Fan Installation

A Flight Investigation of the Thermal Performance of Air Heated Propeller

Theoretical Investigation of Drag Reduction in Maintaining the Laminar Boundary Layer by Suction

Elastic Properties in Tension and Shear of High Strength Nonferrous Metals and Stainless Steel - Effect of Previous Deformation and Heat Treatment

Some Investigations of the General Instability of Stiffened Metal Cylinders 8: Stiffened Metal Cylinders Subjected to Pure Torsion

Buckling Stresses of Simply Supported Rectangular Flat Plates in Shear

An Application of Statistical Data in the Development of Gust-Load Criterions

Supersonic Wave Drag of Sweptback Tapered Wings at Zero Lift

Wind-Tunnel Investigation of the Effect of Power and Flaps on the Static Lateral Characteristics of a Single-Engine Low-Wing Airplane Model

Investigation of the Fuselage Interference on a Pitot-Static Tube Extending Forward From the Nose of the Fuselage

The Stability of the Laminar Boundary Layer in a Compressible Fluid

Charts Showing Relations Among Primary Aerodynamic Variables for Helicopter-Performance Estimation

Spark-Timing Control Based on Correlation of Maximum-Economy Spark Timing, Flame-Front Travel, and Cylinder Pressure Rise

Recurrence Formulas and Differential Equations for Stress Analysis of Cambered Box Beams

Effect of Exhaust Pressure on the Performance of an 18-Cylinder Air-Cooled Radial Engine with a Valve Overlap of 40 Degrees

Effect of Aspect Ratio and Taper on the Pressure Drag at Supersonic Speeds of Unswept Wings at Zero Lift

Investigation of Thrust Losses Due to Shanks of a Flared-Shank Two-Blade Propeller on a Slender-Nose Airplane

Exploratory Investigation of Laminar-Boundary-Layer Oscillations on a Rotating Disk

A Study of Metal Transfer Between Sliding Surfaces

Two-Dimensional Wind-Tunnel Investigation of the NACA 64(Sub 1)-012 Airfoil Equipped With Two Types of Leading-Edge Flap

Performance and Ranges of Application of Various Types of Aircraft-Propulsion System

Wind-Tunnel Investigation of Split Trailing-Edge Lift and Trim Flaps on a Tapered Wing With 23 Degree Sweepback

Iterative Interference Methods in the Design of Thin Cascade Blades

Investigations of Free Turbulent Mixing

Limits of Precision in the Determination of Lattice Parameters and Stresses by the Debye-Scherrer Method

Keyword Search

Published Year

Subject

Author